How do I connect my RTA 1335 /1025W to the engin nDSL network?

Overview

Step 1: Login to your Dynalink RTA1335/1025W
Step 2: Select PPPoE
Step 3: Configure WAN IP settings
Step 4: Enter your PPP username and password
Step 5: Configure LAN settings
Step 6: Summary Page confirmation
Step 7: Connect your modem to the internet
Step 8: Connected

Step 1: Login to the modem

1. Login via http://192.168.1.1 Your username is admin, and the password is admin
2. Go to Quick Setup and deselect the check box below to scan the Internet connection automatically
3. For Australia , the VPI and VCI numbers for your Internet connection will be 8, 35 respectively.
4. Select Next

Step 2: Select PPPoE

1. Select the encapsulation type for PPPoE. It should be LLC/SNAP
2. Select Next

Step 3: Configure WAN IP settings

1. Select Obtain IP address automatically, enable NAT, and leave the MTU as 1492.
2. Select Next
   

Step 4: Enter your PPP username and password

1. Enter your ISP username and password and " Always on"
   
2. Select Next

Step 5: Configure LAN settings

1. Select Obtain IP address automatically, enable NAT, and leave the MTU as 1492.
2. Select Next

Step 6: Summary Page confirmation

1. The Internet Connect Summary will appear confirming your connection details
   
2. Select Next

Step 7: Connect your modem to the internet

1. Your status should be training and ready to connect.
   
2. Select Connect

Step 8: Connected

1. Your ADSL modem should be connected to broadband as per the status screen
   
2. Open up your web browser to verify if you have internet access.