PacketMan VoIP and Internet Knowledgebase / I have an engin voicebox series 1 or 2, how do I setup a static IP and configure port forwarding via the SMC 700x series router?

Search VoIP Help: Adv search

Browse by Manufacturer:

I have an engin voicebox series 1 or 2, how do I setup a static IP and configure port forwarding via the SMC 700x series router?

Email this article

Votes: 0

Posted: 13 Sep, 2007
by: Engin *.

Updated: 30 Nov, 2007
by: Engin *.

Overview

Step 1: Enable the static IP using the telephone connected to the voicebox
Step 2: To check that you have implemented this correctly
Step 3: Login to your SMC router
Step 4: Setup Port Forwarding

Please note you will need to enter the * key to define the periods in the IP address . ie: 10*0*0*10 = 10.0.0.10. Make sure to hang up between each part of this step. After picking up the phone, dial **** to re-enter the config menu.

If you have access to the Sipura web interface, you can avoid step 1 and 2. See KB32.

Step 1: Enable the static IP using the telephone connected to the voicebox.

Dial ****, once you hear the voice, dial 101# followed by 0# 1 - Hang up.
Dial **** once you hear the voice, dial 111#, then 192*168*2*10# 1 - Hang up.
Dial **** once you hear the voice, dial 121#, then 255*255*255*0# 1 - Hang up.
Dial **** once you hear the voice, dial 131#, then 192*168*2*1# 1 -Hang up.

Step 2: To check that you have implemented this correctly

Dial **** 100 # to listen to the state of DHCP(voice should say ‘disabled’)
Dial **** 110 # to listen to yourIP address (should say 192.168.2.10)
Dial **** 120 # to listen to your Subnet Mask (should say 255.255.255.0)
Dial **** 130 # to listen to your Default Gateway (should say 192.168.2.1)

Step 3: Login to your SMC router

To access the Wireless Barricade’s management interface, enter the Wireless Barricade IP address in your Web browser http://192.168.2.1.
Then click LOGIN. (By default, there is no password.)

Step 4: Setup Port forwarding

Go to the NAT Menu > Virtual Server
Enter the Private IP address 192.168.2.10
Enter the Service port: 5060
Enter Protocol Type: UDP
Make sure you enable the rule
Save all changes.