Search VoIP Help:     Adv search
Browse by Manufacturer:
KB Number
PacketMan VoIP and Internet Knowledgebase / Dynalink / Internet Setup Guides / How do I bridge the Dynalink RTA100+?

How do I bridge the Dynalink RTA100+?
Print
Email this article
Views: 1215
Votes: 0
Posted: 06 Aug, 2007
by: Engin *.
Updated: 03 Dec, 2007
by: Engin *.
Overview
Step 1: Login to the RTA100+
Step 2: Enter Configuration Options
Step 3: Disable NAT
Step 4: Save changes

Please reset the modem to factory defaults before continuing. To do so, get a pin or paperclip and insert it in to the reset pinhole on the back of the modem. You'll feel a switch depress; hold the pin or paperclip in for around 20 seconds.


Step 1: Login to the RTA100+
  1. Log in to the modem with the web address: http://192.168.1.1
  2. enter the username: admin -- Password: admin
Step 2: Enter Configuration Options
  1. Select Advanced Configuration
  2. From the options under the tabs and set the following:
  3. Operation Mode to Enabled
    Encapsulation to 1483 Bridge IP LLC
    VPI: 8
    VCI: 35
    Bridge: Enabled
    Default Route: Disabled
    Click [Submit]

Step 3: Disable NAT
  1. Click the Services tab
  2. Click Disable
Step 4: Finish and Submit changes
  1. Click the Submit button
  2. wait for the page to refresh Select Admin from the tabs at the top (right-most tab)
  3. Select Save & Reboot from the options under the tabs Click the Save button, wait for the page to change back to Save & Reboot Click the Reboot button
Others in this Category
document How do I connect my RTA 1335 /1025W to the engin nDSL network?
document How do I connect the Dynalink RTA1335 /1025W modem to the internet using PPPoA?
document How do I bridge my Dynalink RTA220/230
document How do I set my Dynalink RTA1335 in half-bridge (IP Extension) mode?


RSS
Powered by KnowledgebasePublisher (Knowledgebase software)